NailTite™ Sub Floor Adhesive 400
NailTite™ Sub-Floor Adhesive 400 is formulated for heavy-duty construction applications. It forms an effective bond on sub-flooring, exterior sheathing, siding, decking, fences, wet/frozen lumber, pressure-treated wood, drywall, cement board, hardboard, metal, concrete, wood and fiberboard.
To ensure our customers always have access to the most current information, we ask that you contact the Henry Company Customer Support Center at 1-800-486-1278 for more information about this product.
Surfaces should be free from standing water, ice, snow and other foreign materials. Cut the spout at a 45° angle to desired bead size, puncture seal inside of spout and place into gun. Apply the adhesive in a continuous 6mm (1/4”) bead to joists or studs or to backside of siding or panels. Be certain that all outer edges and centers are adequately coated with adhesive to ensure a total bond. Use nails sparingly for support and as an aid to alignment during installation and until adhesive sets. If surfaces are uneven use “spot” build up of adhesive to level the substrate. Floor applications require the use of screws. Do not apply at temperatures below -17°C(0°F).
Approximately 48 hours.
Clean-up with mineral spirits. Dispose in an approved hazardous waste facility.
Approximately 25m (82 lineal feet) of a 6mm (1/4”) bead.
1 year unopened.
The consumer shall satisfy themselves of the suitability of this product for the intended purpose. Weather, applicator's skill and surface conditions are beyond manufacturer's control. We, therefore, limit our liability to replacement of defective material only, within one year of proof of purchase.