NailTite™ Multi-Purpose Construction Adhesive is a high-strength, light construction adhesive for use on plywood, fiberboard, drywall, pressure-treated wood, hardboard and molding. For interior and exterior use.

Features

• Weatherproofs and absorbs impact
• Bridges gaps and irregularities
• Eliminates squeaking

Coverage

• Approximately 25m (82 lineal feet) w/a 6mm (1/4”) bead

Application

Surface must be clean and dry. Cut the spout at a 45° angle to desired bead size, puncture seal inside of spout and place into caulking gun. If applying to panels, pre-fit the panels and then apply the adhesive in a 6mm (1/4”) bead, and a 7.6cm (3”) long skip bead to the stud or back of panels. On existing drywall or plaster surfaces, apply a bead around the outside edges, around openings and on 40.5cm (16”) centers. Press substrates firmly together within 5 minutes of application, then pull apart for 5 minutes to allow for venting. Press firmly back into place. Do not apply at temperatures below -17°C(0°F).

Cure Time

Approximately 48 hours.

Cleaning/Disposal

Clean-up with mineral spirits. Dispose in an approved hazardous waste facility.

Coverage

Approximately 25m (82 lineal feet) of a 6mm (1/4”) bead.

Shelf Life

1 year unopened.

The consumer shall satisfy themselves of the suitability of this product for the intended purpose. Weather, applicator's skill and surface conditions are beyond manufacturer's control. We, therefore, limit our liability to replacement of defective material only, within one year of proof of purchase.