Stone Mason® Floor Patch and Leveler Cement
Stone Mason® Floor Patch and Leveler Cement provides a smooth, level finish on interior subfloors prior to the installation of floor coverings. Fast-setting and premium quality, Floor Patch & Leveler Cement is a polymer-modified Portland cement-based floor patch, leveling and skim coat cement in one.
Surfaces must be structurally sound prior to application of Floor Patch and Leveler Cement. Secure loose boards or tiles with screws, nails and/or recommended adhesive. Substrates must be clean and free from dirt, grease, oil, wax, sealers, mildew, soap film and all loose material. Loose, scaly paint shall be scarified. Concrete must be fully cured and not subject to hydrostatic pressure.
Mix only sufficient material for use within 10 minutes. Always use clean water, containers and tools. Use a ratio of 1 part cold water to 3 parts powder and mix to a smooth, creamy consistency. Apply immediately. For greater adhesion, performance and for applications over cutback adhesives, sheet vinyl, terrazzo, ceramic tile and plywood, use Stone Mason® Acryli Bond in place of water. Avoid excessive mixing and warm water as this will shorten working and hardening time of new mix. Always add powder to liquid when mixing. Avoid using high speed mixing to prevent air entrainment (should not exceed 300 rpm). Mix by hand or by electric drill and paddle for larger mixes. Working time: 10 minutes.
Apply with a putty knife or flat cement finishing trowel. Once dry, sand any surface imperfections to obtain required smoothness.
Initial set is approximately 25-30 minutes and the material will dry within 1-2 hours depending on the applied thickness, temperature and humidity conditions. Once completely dry, installation of new flooring material can commence.
Interior use only. Do not apply directly over gypsum-based substrates. Floor Patch and Leveler Cement is not designed to be a final floor surface and must be overlaid with a suitable floor covering before exposed to traffic. Work in dry climate, at temperatures between 10°C (50°F) and 38°C (100°F). If a level area over 1.5 m2 (5 sq. ft) in diameter is required, use E-Z Flow or Super E-Z Flow Floor Underlayment.
Approximately 1.8 m2 (20 sq. ft) applied at 1.5 mm (1/16") thickness or 0.4 m2 (4.7sq. ft) applied at 6 mm (1/4") thickness.
Clean tools and hands with clean water before material sets.
Corrosive. May cause eye injury. If product gets into eyes, flush repeatedly with water and seek medical attention promptly. Avoid skin contact. If contact occurs, wash exposed skin with water. Protective eyewear should be worn.
AVOID CONTACT WITH EYES.
First Aid Treatment
Cement when mixed with water results in a solution of calcium hydroxide. If splashed in eyes or on skin, flush thoroughly with water.
KEEP OUT OF REACH OF CHILDREN
The consumer shall satisfy themselves of the suitability of this product for the intended purpose. Weather, applicator's skill and surface conditions are beyond manufacturer's control. We, therefore, limit our liability to replacement of defective material only, within one year of proof of purchase.